![packet tracer activity 7.2.2.3 packet tracer activity 7.2.2.3](https://i.gyazo.com/67a21b0792ff9d510baf70ba085e4940.png)
![packet tracer activity 7.2.2.3 packet tracer activity 7.2.2.3](https://itexamanswers.net/wp-content/uploads/2017/07/9.2.2.5-Packet-Tracer-Configuring-Dynamic-NAT-Instructions.jpg)
This interesting traffic will trigger the IPsec VPN to be implemented whenever there is traffic between the R1 and R2 - R3 LANs.
![packet tracer activity 7.2.2.3 packet tracer activity 7.2.2.3](https://itexamanswers.net/wp-content/uploads/2017/07/7.2.3.3-Packet-Tracer-Configuring-an-IPv4-ACL-on-VTY-Lines-Instructions-768x621.jpg)
Configure ACL 101 to identify the traffic from the LAN on R1 to the LAN on R2 and R3 as interesting. Part 3: Configure IPsec Parameters Step 1: Identify interesting traffic on R1.
#PACKET TRACER ACTIVITY 7.2.2.3 LICENSE#
Technology Package License Information for Module:'c2900' -Technology Technology-package Technology-package Current Type Next reboot -ipbase ipbasek9 Permanent ipbasek9 security securityk9 Evaluation securityk9 uc None None None data None None None Packet Tracer – Configuring GRE Over IPsec (Optional) R1# reload c.Īfter the reloading is completed, issue the show version again to verify the Security Technology Package license activation. R1(config)# license boot module c2900 technology-package securityk9 R1(config)# end R1# copy running-config startup-config If not, activate the securityk9 module for the next boot of the router, accept the license, save the configuration, and reboot. Technology Technology-package Technology-package Current Type Next reboot -ipbase ipbasek9 Permanent ipbasek9 security None None None uc None None None data None None None Configuration register is 0x2102ī. Issue the show version command in the user EXEC or privileged EXEC mode to verify that the Security Technology Package license is activated. The Security Technology Package license must be enabled to complete this activity. Part 2: Enable Security Features Step 1: Activate securityk9 module. We will repeat this test after configuring the GRE tunnel over IPsec. Attempt to ping the IP address of PC3 from L2. Attempt to ping the IP address of Server1 from L2. From R1, ping the IP address of S0/0/0 on R3. From R1, ping the IP address of S0/0/0 on R2. Part 1: Verify Router Connectivity Step 1: Ping R2 and R3 from R1. All networks are locally configured, and need only the tunnel and the encryption configured. Scenario You are the network administrator for a company which wants to set up a GRE tunnel over IPsec to remote offices. Packet Tracer – Configuring GRE Over IPsec (Optional) Part 4: Configure GRE Tunnels over IPSec Part 5: Verify Connectivity Objectives Part 1: Verify Router Connectivity Part 2: Enable Security Features Part 3: Configure IPSec Parameters © 2013 Cisco and/or its affiliates. Packet Tracer –Configuring GRE over IPsec (Optional) Topology